Could I help you?

IEEE 484-2019

IEEE 484-2019 IEEE Recommended Practice for Installation Design and Installation of Vented Lead-Acid Batteries for Stationary Applications

standard by IEEE, 07/17/2020

More details

Reduced price!
M00091059
New product
Limited time offer:

$25.20

$56.00

-55%

In stock

- +

Add to compare

 
More info

Full Description

Scope

This recommended practice provides recommended design practices and procedures for storage, location, mounting, ventilation, instrumentation, preassembly, assembly, and charging of vented lead-acid batteries. Required safety practices are also included. This recommended practice is applicable to full-float stationary applications where a battery charger normally maintains the battery fully charged and supplies the direct current (dc) loads. However, specific applications, such as emergency lighting units, semiportable equipment, and alternate energy applications, may have other appropriate practices that are beyond the scope of this recommended practice.The portions of this recommended practice that specifically relate to personnel safety are mandatory instructions and are designated by the word shall; however, all other portions are recommended practices and are designated by the word should.Sizing, maintenance, capacity testing, charging equipment, dry-charged units, and consideration of other types of batteries are beyond the scope of this recommended practice.

Purpose

This recommended practice provides a general format for the preparation of test procedures and suggests the points to be considered by technical committees in the preparation of specific instructions for the thermal evaluation of insulation systems for electrical equipment. The thermal evaluation of an insulation system involves the following thermal factors of influence:a) Exposure temperatureb) Ambient temperaturec) Temperature gradientd) Rate of temperature change

Abstract

Revision Standard - Active.Recommended design practices and procedures for storage, location, mounting, ventilation, instrumentation, preassembly, assembly, and charging of vented lead-acid batteries are provided. Required safety practices are also included. These recommended practices are applicable to all stationary applications. Specific applications, such as emergency lighting units, semiportable equipment, and alternate energy applications, may have other appropriate practices and are beyond the scope of this recommended practice.

 
Custom tab

This is a custom block edited from admin panel.You can insert any content here.

30 other products in the same category:

Compare 0

No products

To be determined Shipping
$0.00 Total

Check out