Could I help you?

ASTM D1929-13a

ASTM D1929-13a Standard Test Method for Determining Ignition Temperature of Plastics

standard by ASTM International, 11/15/2013

More details

Reduced price!
M00074687
New product
Limited time offer:

$27.00

$60.00

-55%

In stock

- +

Add to compare

 
More info

Full Description

1.1This fire test response test method2 covers a laboratory determination of the flash ignition temperature and spontaneous ignition temperature of plastics using a hot-air furnace.

1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3Caution-During the course of combustion, gases or vapors, or both, are evolved that have the potential to be hazardous to personnel.

1.4This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire-hazard or fire-risk assessment of the materials, products, or assemblies under actual fire conditions.

1.5Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 1.3 and 1.4.

Note 1-This test method and ISO 871-1996 are identical in all technical details.

 
Custom tab

This is a custom block edited from admin panel.You can insert any content here.

30 other products in the same category:

Compare 0

No products

To be determined Shipping
$0.00 Total

Check out