Could I help you?

ASTM F3039-13

ASTM F3039-13 Standard Test Method for Detecting Leaks in Nonporous Packaging or Flexible Barrier Materials by Dye Penetration

standard by ASTM International, 11/15/2013

More details

Reduced price!
M00074669
New product
Limited time offer:

$26.10

$58.00

-55%

In stock

- +

Add to compare

 
More info

Full Description

1.1This test method defines a procedure that will detect and locate a leak equal to or greater than a channel formed by a 50 m [0.002 in.] wire in the edge seals of a nonporous package. A dye penetrant solution is applied locally to the seal edge to be tested for leaks. After contact with the dye penetrant for a minimum specified time, the package is visually inspected for dye penetration or, preferably, the seal edge is placed against an absorbent surface and the surface inspected for staining from the dye.

1.2This test method is used for both transparent and opaque nonporous surfaces.

1.3This test method requires that the dye penetrant have good contrast to the materials being tested and/or the absorbent surface.

1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
Custom tab

This is a custom block edited from admin panel.You can insert any content here.

30 other products in the same category:

Compare 0

No products

To be determined Shipping
$0.00 Total

Check out