Could I help you?

ASTM G174-04(2017)

ASTM G174-04(2017) Standard Test Method for Measuring Abrasion Resistance of Materials by Abrasive Loop Contact

standard by ASTM International, 07/15/2017

More details

Reduced price!
M00071458
New product
Limited time offer:

$21.60

$48.00

-55%

In stock

- +

Add to compare

 
More info

Full Description

1.1This test method covers ranking rigid engineering materials for abrasion resistance in rubbing against aluminum oxide abrasive finishing tape. Though most solids can be tested, this test method addresses its use for metals, and coatings applied to metals.

1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
Custom tab

This is a custom block edited from admin panel.You can insert any content here.

30 other products in the same category:

Compare 0

No products

To be determined Shipping
$0.00 Total

Check out