Full Description

1.1This test method covers the determination of the extent to which a grease retards the rotation of a slow-speed ball bearing by measuring starting and running torques at low temperatures (below18C (0F)).

1.1.1Torque measurements are limited by the capacity of the torque-measuring equipment.

1.1.2This test method is not suitable for greases exhibiting torque values greater than 50000gcm at the selected test temperature.

Note 1:When initially developed, the original dynamometer scale limited the torque capacity to approximately 30000gcm; the original dynamometer scale is obsolete, however. The suggested replacement scale has not been evaluated; it could extend the limit to approximately 50000gcm.

1.2The values stated in SI units are to be regarded as standard.

1.2.1Exceptions-The values given in parentheses are for information only. The exception is torque values that are given in cgs-metric units, which are widely used in grease specifications.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard and warning statements, see 6.1.1, 7.2, 7.4, 8.7, and 8.11.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.